I am having an issue with a library model in Moldwizard.
When using the ejector pin post processing it works correctly to trim ejector pins down to a surface, but I get an error when trying to untrim.
The error says "Internal error: an attempt was made to access an attribute not in the relevant class"
I assume there is an attribute that needs to be set up for this pin and it isn't working properly.
When using the ejector pin post processing it works correctly to trim ejector pins down to a surface, but I get an error when trying to untrim.
The error says "Internal error: an attempt was made to access an attribute not in the relevant class"
I assume there is an attribute that needs to be set up for this pin and it isn't working properly.