Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
EIA Torque Specs
- Thread starter brunodg1
- Start date
The exact value may depend in the size of the waveguide, and the hardware used. Typical values might be on the order of 10 inch-pounds (note INCH-pounds, not foot-pounds). Some might be a bit lower, sime might be significantly higher.
If you're dealing with high power and/or pressurized waveguide, or sizes much smaller or larger than 'middle of the pack' X-band WR90, then you *really* need to track down the applicable spec for your system.
If you're dealing with high power and/or pressurized waveguide, or sizes much smaller or larger than 'middle of the pack' X-band WR90, then you *really* need to track down the applicable spec for your system.
- Status