We run SolidWorks but had CadKey99 up to a couple years prior to my arrival. I'm working on a project where I'm importing a DXF into CK, all is fine except the extension line extends way past the dimenstion line. I'd rather not re-dimension the whole part, what can I do to edit the existing dimensions?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Editing extesion lines after importing DXF into CadKEY
- Thread starter kldkwu
- Start date
Similar threads
- Locked
- Question