Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Edison Base Call-out? 2

Status
Not open for further replies.
MadMango

MadMango

Mechanical
Joined
May 1, 2001
Messages
6,992
Location
US
Looking for information on proper call-out for external Medium Edison Base (E26) threads found on common light bulbs? I don't see a sample call-out in ANSI/UL 1598 or 496.

"Art without engineering is dreaming; Engineering without art is calculating."

Have you read faq731-376 to make the best use of these Forums?
 
Sort by date Sort by votes
You just saved me a lot of hair pulling!

"Art without engineering is dreaming; Engineering without art is calculating."

Have you read faq731-376 to make the best use of these Forums?
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Gaganaut06
  • Locked
  • Question Question
Call out for a pattern of concentric holes
Replies
11
Views
5K
Gaganaut06
Gaganaut06
FrancoisY
  • Locked
  • Question Question
Datum call out on a hole
Replies
1
Views
546
Garland23
Garland23
cobra46
  • Locked
  • Question Question
HELP!!! How should I call out my intent
2
Replies
21
Views
2K
3DDave
3DDave
Gregg369
  • Locked
  • Question Question
How do I interpret this call out?
Replies
9
Views
1K
Belanger
Belanger
efulm4444
  • Locked
  • Question Question
Best way to call out surface finish after machining vs after alodine coating
Replies
9
Views
2K
drawoh
drawoh

Part and Inventory Search

Sponsor

Back
Top