Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Edge-to-Edge Contact

Status
Not open for further replies.
vaseand

vaseand

Nuclear
Joined
Nov 17, 2013
Messages
1
Location
GB
I've got a 2D model which is a block with a slot and a thin sheet touching on one edge. I've use contact mesh to define CGAP elements along the contact edge and set the gap stifness however when I run the model, the thin sheet passes straight through the block. I've used ADVNL 601,106.

Is there a flag to switch on contact that I've missed?
 
Status
Not open for further replies.

Similar threads

vnet
  • Locked
  • Question Question
Native NX to Solid Edge
Replies
3
Views
569
Toost
Toost
imti7
  • Locked
  • Question Question
Unable to snap an edge of shaft model to create dimension !
Replies
1
Views
298
JohnRBaker
JohnRBaker
Halasox
  • Locked
  • Question Question
NXOPEN Add edge blend to each part in an assembly
Replies
2
Views
523
Halasox
Halasox
imti7
  • Locked
  • Question Question
How to give Full round edge blend or fillet choosing three faces?
Replies
8
Views
1K
imti7
imti7
CAD2015
  • Locked
  • Question Question
Is it possible to convert cgm to drawing?
Replies
2
Views
2K
CAD2015
CAD2015

Part and Inventory Search

Sponsor

Back
Top