I am using Beam 188 to modal the following beam in Ansys APDL. I am confused about applying point load Fz and Fy as the forces are certain distance above element node( top of beam section) as shown in section A. Can any one help me to guide how can I apply this eccentric load . Than you !!!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Eccentric loading in APDL
- Thread starter RHamal
- Start date
Similar threads
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question