Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

E&H FRM51 Level error reading

Status
Not open for further replies.
sumguy

sumguy

Electrical
Jun 4, 2007
1
We recently installed a FMR51 – X267/0 transmitter on a vertical vessel that approx. 127” in height. There is a mixer in the vessel and the propellers are 10” off the bottom. The mixer is slow ~50rpm. The radar is reading correctly except for the when the mixer is on and the level is below the propellers, when this happens the signal reads full scale. Is there an explanation? Thanks
 
Status
Not open for further replies.

Similar threads

Bigwiggz
  • Locked
  • Question
I&C Engineer for Nuclear Industry
Replies
5
Views
1K
electricpete
electricpete
BPW363
  • Locked
  • Question
Communications protocol error codes (Modbus TCP, Modbus RTU, Fiber Optic TCP etc.)
Replies
2
Views
799
danw2
danw2
EEENGRX
  • Locked
  • Question
Level transmitter tripped a solenoid operated valve immaturely 1
Replies
6
Views
827
hacksaw
hacksaw
Ciaci
  • Locked
  • Question
Electrical Components for Water Heating Experiment
Replies
7
Views
5K
Compositepro
Compositepro
helpyou
  • Locked
  • Question
voltage drop & high alarm 1
Replies
14
Views
486
danw2
danw2

Part and Inventory Search

Sponsor

Back
Top Bottom