Cockroach
Mechanical
- Jan 17, 2003
- 1,104
I have been successful with this forum in the past to dynamic load a Compression Spring and automate height based on a moving part.
I would like to do the same with a Torsion Spring. How can I show a straight arm rotating 90 degrees from the relaxed position? Is there a site or perhaps a lead on how to do this?
Kenneth J Hueston, PEng
Principal
Sturni-Hueston Engineering Inc
Edmonton, Alberta Canada
I would like to do the same with a Torsion Spring. How can I show a straight arm rotating 90 degrees from the relaxed position? Is there a site or perhaps a lead on how to do this?
Kenneth J Hueston, PEng
Principal
Sturni-Hueston Engineering Inc
Edmonton, Alberta Canada