Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting, Dimensions in view Disappearing

Status
Not open for further replies.

Champagne

Aerospace
Joined
May 2, 2003
Messages
1
Location
US
Hello,

Currently I have come across this problem where dimensions in certain views on certain sheets have disappeared. I tried to put them back in but the new dim also vanasihes to. Other drafting eneties are being affected to such as my centerline from hole to hole, those have disappeared and also disappear when I reinsert them. Just wandering if any has come across this in SW2003.

 
You may want to check your annotations folder, in the drawing mananger tree, and make sure that show reference dimensions is checked.

BBJT CSWP
 
If your drawing has layers, make sure the active layer, where new dims, notes, sketch lines, etc. are being added, is set to be visible. I had this frustrating yet simple problem once and sure enough, I made that layer visible and there were all those pesky dims and notes that kept disappearing!

Steve
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top