Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Does SAP 2000 analyze and design warping? 1

Status
Not open for further replies.
cprr0107

cprr0107

Structural
Joined
Jul 6, 2010
Messages
13
Location
PH
Does SAP 2000 analyze and design warping?
How can I display output considering warping in steel sections?
please help..
thanks in advance!!
 
Sort by date Sort by votes
No it doesnt for frames

use shells, model properly and display the shear stresses. But even then you wont be able to isolate St Venants from warping.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

N
  • Question Question
SAP 2000 - Center of Mass and Center of Rigidity
Replies
0
Views
5K
Neeka
N
giofed
  • Locked
  • Question Question
SAP 2000 Shell twisting moment
Replies
1
Views
1K
JoshPlumSE
JoshPlumSE
Amogh Deshpande
  • Locked
  • Question Question
Can I model and analyze a multi-sto
Replies
2
Views
1K
JoshPlumSE
JoshPlumSE
A
  • Locked
  • Question Question
CSI BRIDGE "Design request" for Precast Concrete I Girder bridge does not work when the defined beam is nonprismatic !!!
Replies
0
Views
886
Abderrahmane Mche
A
a_urbs
  • Locked
  • Question Question
Using Section Cuts in SAP for Storey Weight
Replies
0
Views
1K
a_urbs
a_urbs

Part and Inventory Search

Sponsor

Back
Top