Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Display freeze after doing a 'Save As...' step file using journal

Status
Not open for further replies.

claforet

Mechanical
Joined
Apr 8, 2010
Messages
54
Location
US
I'm using NX5 and trying to write a journal that will convert an assembly to step, jt, and parasolid. I finally found that the only way to get the journal (in NX5) to convert the assembly to step was to use the "Save As" rather than Export. When I do this by running the journal, it saves the step file correctly, but it causes the display in UG to freeze (can't rotate, zoom, move, etc) but all the functionality is still there. When I do Save As without a journal, there is no problem. Has anyone encountered any similar problems?

Thanks.
 
This is unlikely to be the answer your after but ...
I had some problems exporting images when I changed to a dual-monitor setup.
I've found that I must have NX on my 'primary monitor' for it to export properly (or at all).
Hope you find your answer,
Jon

Jon S

Medical Design Engineer - Glos. UK
NX 6.0.4.3 / TCE V10.0.3.8.6
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top