Disabling drag snap in an assembly

[samuelm]

All,

I have an assembly that I must have enabled a snap feature by accident. When dragging a component it wants to snap at approx. 10mm intervals. Other details are that it snaps only in the Y axis, when dragging in the other directions the part drags smoothly and this behavior does not exist on other assemblies open concurrently. I have already searched the forum and have looked at my document and system Grid/Snap and Relations/Snaps settings which appear to be only geared for sketches and not assemblies.

SW 2010 Standard.

Any thoughts?

Thanks,

Sam

 

[ctopher]

Did you check Help?
SW 2010 Help

Chris, CSWA
SolidWorks 14
SolidWorks Legion