Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

DIN STANDARDS

Status
Not open for further replies.
Rich01

Rich01

Mechanical
Joined
Apr 23, 2001
Messages
3
Location
CA
Anybody can tell me if there is a DIN standard for hot rolled steel bar products (round or square) that exists beside DIN-1014-1 and DIN-1014-2?

the tolerances I'm looking for in these products is a plus or minus 0.25mm on side lenght deviation.

Thanks.
 
Status
Not open for further replies.

Similar threads

willrsawyer
  • Locked
  • Question Question
Application of CSA standards to imported end-user products
Replies
1
Views
1K
Enable
Enable
rivtim
  • Locked
  • Question Question
Din 17111
Replies
1
Views
196
TVP
TVP
cagrisever
  • Locked
  • Question Question
steel grades and standards
Replies
12
Views
361
EdStainless
EdStainless
Berniedog
  • Locked
  • Question Question
OHSA Standards for Column baseplates
Replies
1
Views
184
rholder98
rholder98
tooling1
  • Locked
  • Question Question
equivalent to din standards
Replies
0
Views
127
tooling1
tooling1

Part and Inventory Search

Sponsor

Back
Top