Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Dimensioning

  • Thread starter Thread starter kenjg
  • Start date Start date
K

kenjg

Guest
Hello All,

I know I did not do this correct, so that's why I'm here. Can someone please help me in dimensioning this attached bracket drawing? I never have done this before as you can tell. Thanks a million in advance.

KenJG

SW 2013 Prem 64-bit
 

Attachments

You must log in or register to reply here.

Similar threads

powerhound
  • Locked
  • Question Question
Dual dimensioning and dimension format
Replies
8
Views
2K
ctopher
ctopher
aleksandar81
  • Locked
  • Question Question
Dimensioning section in drawing
Replies
4
Views
345
aleksandar81
aleksandar81
M
Dimensioning a Taper
Replies
0
Views
2K
Matthew D
M
farzadtb
  • Locked
  • Question Question
Create horizontal and vertical Dimensioning after / from Intelligent Dimensioning
Replies
8
Views
380
SBaugh
SBaugh
justindustrial
  • Locked
  • Question Question
SW2015 Best Practices: Dimensioning Patterned Holes on Curved Parts
Replies
4
Views
725
SBaugh
SBaugh

Part and Inventory Search

Sponsor

Back
Top