Dimensioning

[kenjg]

Hello All,

I know I did not do this correct, so that's why I'm here. Can someone please help me in dimensioning this attached bracket drawing? I never have done this before as you can tell. Thanks a million in advance.

KenJG

SW 2013 Prem 64-bit

 

[fishface68]

Hi Ken,
Not sure what you mean by not correct there is almost enough to construct the part from the drawing the only issue I can see is that sketch 1 is not dimensioned and therefore not fully constrained. You can see that because the drawing is blue, it will turn black when it is fully constrained.

best wishes Pat