Only full dimensions, not half (from this level to somewhere else)Able to create half dimensions only while creating the dimension but not change it later. Can’t create a dimension from A to B where B is outside the drawing. Then I would like a dimension with double arrows pointing to B but ending on the paper. Can’t shorten the dimension line.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Dimensioning
- Thread starter Akesson
- Start date