Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Difference between 110 V & 220 V 1

Status
Not open for further replies.

GreatIraq

Electrical
Mar 11, 2009
7
Dear All

What is the difference between 22oV 50HZ & 110 V 60HZ ? which is the cheaper between the two ?

If we have 220-240 V 50HZ systeem & the frequency raise more than 50 HZ what's happen to the equipments & what's behavior of the system !!!!!!

Pls. Check & Advise
Thanks lot inadvance
Cheers
 
Replies continue below

Recommended for you

IEC versus NEC. Lot of restrictions in the NEC for use of 220v. What is the application?
 
A voltage doesn't really have a price. The magnetics for 50hz systems will cost 1/6th more than the magnetics for 60hz systems.

You have not provided enough detail to anwer the question. Different components respond to a frequency change differently. Do you want to run a 50hz system on 60hz?
 
220V is economical hands down. Besides requiring a smaller conductor (less copper) for a given load, 220V systems does not require a intervening transformer as 400Y/220V systems provides it directly.

110V or more typically 208Y/120V systems requires additional step-down transformers in commercial/industrial facilities where common equipment voltage is 480Y/277V.

Economics plays a greater role outside of the USA. Many legacy systems in the USA were adopted when money was lesser of a concern (and still is for major part, despite all hue and cry about saving money).

Rafiq Bulsara
 
I missed that you second question was totally different. The issue of use 50 Hz equipment on 60 Hz systems and vice versa has been discussed quite a few times in this forum. Do a search for them.

Rafiq Bulsara
 
The correct answer your question is:-
110V
10HZ
But I don't think this will help much.
I respectfully suggest you get some books out of the library and look at the relationship between power, voltage, current, resistance, frequency etc.
Apologies if you come from a place where books are scarce but you obviously have an internet connection and there is plenty info on the World Wide Web.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor