Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

design simulation

Status
Not open for further replies.
ullhas58

ullhas58

Mechanical
Joined
May 13, 2013
Messages
4
Location
IN
hi,
I have generated design simulation for a typical cantilever type al squre section, applied load on one side etc. report is created. I want to know how to view image? or view report?
 
Sort by date Sort by votes
what do you want to see?

displacements?

disp(plot)=all

stress?
stress(plot)=all

...
 
Upvote 0 Downvote
Hi
What version of Nastran are you using (Autodesk/MSC/NX) and what postprocessor?

Leo16 describes how to make the solver do it. But as I understand it, that is not the question. Correct?

Thomas
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Spyros07
  • Locked
  • Question Question
FSI Staggered Simulation
Replies
2
Views
356
Spyros07
Spyros07
MarianaM43
  • Locked
  • Question Question
Structural Simulation - No results are found
Replies
1
Views
594
MarianaM43
MarianaM43
struclearner
  • Locked
  • Question Question
Response Simulation Analysis Restraints and Enforced Motion Location
Replies
2
Views
312
dfreire
dfreire
IngCane
  • Locked
  • Question Question
Optistruct/Nastran Transient Response - Wing simulation
Replies
3
Views
344
IngCane
IngCane
kll123
  • Locked
  • Question Question
Nastran Explicit nonlinear simulation error
Replies
3
Views
295
jacksonfem
jacksonfem

Part and Inventory Search

Sponsor

Back
Top