S
srosendal
Guest
Hi
I am doing an optimization study on a steelframe I made in
WF4. I would like to optimize the frame total mass by
changing parameters by height and width of beam and by
thickness of beam, without exceeding 240 MPa
I would like to use beam idealization also, but when I do
that, I can not calculate the voulume, hence total load.
I am doing an optimization study on a steelframe I made in
WF4. I would like to optimize the frame total mass by
changing parameters by height and width of beam and by
thickness of beam, without exceeding 240 MPa
I would like to use beam idealization also, but when I do
that, I can not calculate the voulume, hence total load.
