Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

design of 'push out' switch aperture in plastic case

Status
Not open for further replies.

luvlyjubblytoo

Mechanical
Joined
May 17, 2006
Messages
7
Location
GB
I am in the process of designing a remote control plastic box.This will be a multi-purpose box with a minimum of 1 and a maximum of 8 pushbuttons. The design brief does not include for blanking plugs so I need design parameters to enable all pushbutton locations to be a 'push out' from the lid. Each pushbutton is about 14mm x 14mm.

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top