Laura Simiyu
Student
Are there any standards used in the design of fillet radius for closed geometries such as triangle, pentagon etc? Thank you
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
DESIGN OF FILLET RADIUS
- Thread starter Laura Simiyu
- Start date
- Status
driftLimiter
Structural
Look at material specific standards. Will depend on the material, the process used to form it etc.
- Status
Similar threads
- Locked
- Question