Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Dents

Status
Not open for further replies.
mithuntech

mithuntech

Mechanical
Joined
Jan 21, 2013
Messages
4
Location
AE

References
For pipelines under ASME B31.4, Clause 434.5.
For pipelines under ASME B31.8, Clause 841.2.4(c).

Query
Both the referred clauses specifies dent as a percentage of nominal pipe diameterfor pipe diameter greater than 12".
Please could you confirm whether it is referring to nominal outside diameter

Regards,

 
Sort by date Sort by votes
Above 12" nom pipe size in inches and OD are the same thing so yes, I would go for OD.

Remember - More details = better answers
Also: If you get a response it's polite to respond to it.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Dario2002
  • Locked
  • Question Question
Tool for measure dents
Replies
1
Views
367
Rich2001
Rich2001
mohd
  • Locked
  • Question Question
GOUGE & DENTS
Replies
3
Views
266
ralphsare
ralphsare

Part and Inventory Search

Sponsor

Back
Top