Deficiencies Warnings Report ??

[steveking]

My question is. Is it possible to turn off the "suppress warning messages" deficiencies on an individual component basis instead of a global selection? An example would be, flanges where I don't provide studs/nuts or gaskets for a nozzle. If we have a manway with blind then we provide studs/nuts and gasket. Other nozzles, responsibility would end at the face of flange. It seems to me, if we have to chose these items on the nozzle calc ( when we do not provide these items) we would be assuming some sort of liability? This would then not show those items as a warning. thanks in advance and bear with me, I'm new.

 

[steveking]

I can't be the first one to ask this question? Someone must have an answer, opinnion, or fix?

 

[TomBarsh]

Steve,

COMPRESS does not provide the option to disregard or suppress Warnings on an individual basis.

Note, you may wish to send your questions directly to Codeware. Try using the web-based contact forms on the Codeware website (

http://www.codeware.com/support/support_center.html)

or direct e-mail to support 'at' Codeware.com.



"Although this forum is monitored by Codeware it is not intended as a venue for technical support and should not be used as the primary means of technical support."

Tom Barsh
Codeware Technical Support

http://www.codeware.com