Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

defaulting

Status
Not open for further replies.
pedromorgan

pedromorgan

Mechanical
Joined
Jul 23, 2006
Messages
14
Location
GB
Autocad 14 question,

When drawing sircles I almost always use TTR but it always defaults to certre point. Is there a way of changing this?

Peter
 
Sort by date Sort by votes
Peter,

can you tinker a button in R14? If yes, try:
^C^C_circle;ttr

Lothar

R14, puh long time ago...:-)

ADT 2004
ACAD 2002
 
Upvote 0 Downvote
Thanks for the reply. i will try that.

I actually have ACAD 2006 sitting on my desk but i dont yet have a computer powerfull enough to run it! but that will change soon.

Thanks again

Peter
 
Upvote 0 Downvote
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top