Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Dear members What is the related
- Thread starter arash807
- Start date
If the dimensions you need are for flanged angle globe valves below Class 600, in the U.S. it's ANSI/ISA-75.08.08-1999 (R2007) - Face-to-Centerline Dimensions for Flanged Globe-Style Angle Control Valve Bodies (Classes 150, 300, and 600).
xnuke
"Live and act within the limit of your knowledge and keep expanding it to the limit of your life." Ayn Rand, Atlas Shrugged.
Please see FAQ731-376 for tips on how to make the best use of Eng-Tips.
xnuke
"Live and act within the limit of your knowledge and keep expanding it to the limit of your life." Ayn Rand, Atlas Shrugged.
Please see FAQ731-376 for tips on how to make the best use of Eng-Tips.
As xnuke explains, most international valve standards will now includse this as a standard. Apart from this, you can quite often come across misfits when replacing old valves. Reason: older might be nonstandard (older 'factory' standards or practise).
Advice: for new constructions: check relevant standard and desccribe.
Replacing: check relevant standard. If replacing non-standardized, use new standard and rebuild. Mostly newer are shorter pattern and extension rings etc. can be utilized to give full length.
- Thread starter
- #4
- Status
Similar threads
- Question
