I have a Datatranslation DT300 A/D card. Well I installed the driver and the example programs work fine. But now I want to measure more channels - how can I separate the values measured by the card? The card output seemes to be channel 1, channel 2, channel 3... but how to separate them to record them?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Datatranslation cards and Labview
- Thread starter AeroM
- Start date
analogkid2digitalman
Electrical
AeroM
Have you tried it using Data Translations DT-LV link software (free for download). I would expect there may be examples and help there.
If not, are the cahnnel values stored in an array?
Wheels within wheels / In a spiral array
A pattern so grand / And complex
Time after time / We lose sight of the way
Our causes can't see / Their effects.
Have you tried it using Data Translations DT-LV link software (free for download). I would expect there may be examples and help there.
If not, are the cahnnel values stored in an array?
Wheels within wheels / In a spiral array
A pattern so grand / And complex
Time after time / We lose sight of the way
Our causes can't see / Their effects.
- Status
Similar threads
- Locked
- Question
- Locked
- Question