Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Damage Re-anodizing over MIL-A-8625 Type III
- Thread starter kevlar49
- Start date
It is technically possible. Softening of the original layer is not a problem. Chipping and spalling where the new/old layers meet could be a problem, so discuss it with the anodizer and if it is in a critical location, you may want to go in a different direction.
- Status
Similar threads
- Locked
- Question
