Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

D1.6 SAW Prequalification

Status
Not open for further replies.
holdpt

holdpt

Structural
Joined
Oct 10, 2011
Messages
82
Location
US
All,
Please advise if I am interpreting 3.6 in 2007 D1.6 correctly. It is saying that a SAW weld can be prequalified if a manufacturer has its flux paired with an electrode as long as I perform the 3 steps listed? If the manufacturer does not pair a flux with an electrode then I need to perform a test per Clause 4?

Thanks!
 
Status
Not open for further replies.

Similar threads

kingnero
  • Locked
  • Question Question
Upgrading SAW wire+flux combination according to AWS A5.17
Replies
9
Views
741
kingnero
kingnero
tweimer48
  • Locked
  • Question Question
AWS Prequalified Fillet Welds -- Where can I get a joint designation for fillet welds? (D1.6)
Replies
2
Views
369
Mr168
Mr168
Fizza453
  • Locked
  • Question Question
PREQUALIFICATION OF WPS?
Replies
2
Views
163
qcrobert
qcrobert
cyoungs
  • Locked
  • Question Question
SAW Qualifications
Replies
3
Views
192
gtaw
gtaw
xaverina1937
  • Locked
  • Question Question
SAW and FCAW
Replies
3
Views
173
SectionIX
SectionIX

Part and Inventory Search

Sponsor

Back
Top