Curve pattern in an assembly.

[GoWithTheFlo]

High everyone!

I have a question about patterns along a curve. I know it is possible to do this in parts, but I want to repeat a part in an assembly along an oblong hole.

Is it possible?

Thank you.

 

[ShaggyPE]

This was a limitation within 2004 when I needed to do a pattern of components along a curve. I am not sure if this capability has been added to newer versions.

-Shaggy

 

[GoWithTheFlo]

Thank you,

I did not find a way either. I think I will have to post them all manually. I will make an enhencment request.

Thanks

 

[ParaCAD]

What version of SW are you using?

Adam
Solidworks 2005 SP01.1
Windows 2000

 

[GoWithTheFlo]

ParaCAD

I am using SW 2006 SP 4.1