Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Curature Anaylsis...

  • Thread starter Thread starter CPAERO
  • Start date Start date
C

CPAERO

Guest
I am trying to find the curvature of a few different arcs and curves, but I am having trouble figuring out how to compare the results to the analytic solution which is sampled along the z-direction. (Figure attached at bottom...)


How do I either:


Find the coordinates at the sampled points that Pro/E uses to analyze


OR


Sample along the z-direction for the curvature analysis rather than the arc length





Thanks for the help
 
You must log in or register to reply here.

Part and Inventory Search

Sponsor

Back
Top