Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cross-Section Drawing of a Hilmer Joint

Status
Not open for further replies.
mbiegert

mbiegert

Electrical
Joined
Jul 26, 2002
Messages
3
Location
US
Hi folks,

I am trying to recall the construction of a Hilmer joint. Unfortunately, it has just been too long since I saw one. This joint was used to mate two sections of underwater vehicles together. Does anyone have a drawing they could make available?
 
Status
Not open for further replies.

Similar threads

Nut Blaster
  • Locked
  • Question Question
Grounding of EGCs locally on a 480V HRG system
Replies
1
Views
1K
TugboatEng
TugboatEng
O
  • Locked
SESAM USFOS - TURNING OF LOCAL DENTING OF BRACES
Replies
0
Views
1K
OJLSLPE
O
JoeBobJenkins
  • Question Question
Looking for a replacement for bronze sil-brazed unions
Replies
5
Views
13K
JoeBobJenkins
JoeBobJenkins
NickParker
  • Locked
  • Question Question
Parallel operation of Emergency generator with Main/Essential Generator
Replies
5
Views
3K
TugboatEng
TugboatEng
mrmalcolm
  • Locked
  • Question Question
Qualification of surface tolerant coatings
Replies
2
Views
1K
mrmalcolm
mrmalcolm

Part and Inventory Search

Sponsor

Back
Top