Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

cross seam welding

Thread starter comic
Start date Jul 3, 2002

Status: Not open for further replies.

Jul 3, 2002

comic

Mechanical

I have a problem with my cross seam welder. I'm welding 0.3mm stainless steel. I am getting a good weld except for its leaving what I call a "pixie hair". At the end of th e weld it seems to pull the tiniest amount of material out and leaves this hair on the part. I have tried many things with no effect. Does anyone have any suggestions.Thanx Matt