D
design-engine
Guest
Where did the 'extend' in Sheetmetal go in Creo 2.0???
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
- Thread starter
- #2
D
design-engine
Guest
haha... found it. 
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question