P
Pupp1286
Guest
So i'm used to working with WF4, and in there, preselection highlighting only included the lined geometry tohighlight on hover/preselect.
In Creo, it's set up to preselect the lined geometry as well as the surfaces of the geometry.
This is VERY annoying when you overlay two nearly identical parts on top of each other to check for differences. It is too much color change at once and the small details are near-impossible to discover.
Is there a way to change this (config or otherwise)to the "old" (lines to preselect, but NOT the surfaces)way?
In Creo, it's set up to preselect the lined geometry as well as the surfaces of the geometry.
This is VERY annoying when you overlay two nearly identical parts on top of each other to check for differences. It is too much color change at once and the small details are near-impossible to discover.
Is there a way to change this (config or otherwise)to the "old" (lines to preselect, but NOT the surfaces)way?
