structured
Structural
I am using SAFE V12 to analyze a two-way concrete floor slab. The default creep coefficient is 2, but I am not sure if this is correct. Is the creep coefficient the same as the deflection factor in ACI 318 9.5.2.5?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Creep Coefficient
- Thread starter structured
- Start date
- Status