Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

creating Cpoint on custom part

Thread starter CADone
Start date Jul 9, 2009

Status: Not open for further replies.

Jul 9, 2009

CADone

Mechanical

Hi All,
I am looking to learn for a method to create a Cpoint on a custom PCB board. This thread discuss a lot about inserting a component from library. see ... thread559-183926

In my application i dont need to insert any component. I have to use my own parts.

Any body has any tutorials?

C1