Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Creating a raised 3D image

  • Thread starter Thread starter TheHitman04
  • Start date Start date
T

TheHitman04

Guest
Hi all, I want to make some 3d plaques/badges but im not sure how to actually model them. Something like this

5f518c48-c2d7-42e7-95d4-c933b62aadee.jpg

il_340x270.378240540_qm2f.jpg

24211-2.jpg


My girlfriend has 2 horses so i was going to try and use 2 pictures of her horses and make 2 plaques with the raised head and then its name on the plaque somewhere, so, can i create this sort of model with only a 2d flat image of the heads? and if so, how would i go about doing it? Theres a few more other things i want to do but this is probably the most complex out of them

Thanks in advance
 

Part and Inventory Search

Sponsor

Back
Top