Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
CPI Separator Design Assistance 1
- Thread starter Watro
- Start date
- Thread starter
- #3
Ash
We need to design a system for 50 m3/hr with a feed oil of 150 mg/l, 100 mg/l TSS with an oil droplet size of 30 micron and above.
Removal of oil should be >90%. I am looking for design guidelines or simple spread sheet to see the basic sizes of the tank, required plate pack, pack volume
We need to design a system for 50 m3/hr with a feed oil of 150 mg/l, 100 mg/l TSS with an oil droplet size of 30 micron and above.
Removal of oil should be >90%. I am looking for design guidelines or simple spread sheet to see the basic sizes of the tank, required plate pack, pack volume
-
1
- #4
Do you know what the SG of the oil is?
My assumption is , that given you are planning to use a CPI that the oil is mostly non emulsified. Is this correct?
Plate separators generally work better with oil drops 60 micron or larger. This is especially important because you are looking for high removal efficiencies.
As a starting point you can process about 0.5m3/hr per m2 of plate area if you have 60 micron or larger oil droplets and the SG is about 0.9.You are probably going to need a lot more area or a lower loading rate if most of your droplets are a lot smaller than 30 micron. Alternatively the removal efficiency will be lower.
Regards
Ashtree
"Any water can be made potable if you filter it through enough money"
My assumption is , that given you are planning to use a CPI that the oil is mostly non emulsified. Is this correct?
Plate separators generally work better with oil drops 60 micron or larger. This is especially important because you are looking for high removal efficiencies.
As a starting point you can process about 0.5m3/hr per m2 of plate area if you have 60 micron or larger oil droplets and the SG is about 0.9.You are probably going to need a lot more area or a lower loading rate if most of your droplets are a lot smaller than 30 micron. Alternatively the removal efficiency will be lower.
Regards
Ashtree
"Any water can be made potable if you filter it through enough money"
That is a relatively small oil/water separator.
Most users will buy a pre-engineered and prefabricated unit rather than constructed a custom made unit.
Refer to the brochure from Siemens:
Siemens Link
Most users will buy a pre-engineered and prefabricated unit rather than constructed a custom made unit.
Refer to the brochure from Siemens:
Siemens Link
My comment above should read:
"You are probably going to need a lot more area or a lower loading rate if most of your droplets are a lot smaller than 60 micron."
I would agree with bimr comment on design and construction of such a unit. Buy one off the shelf if you can. But look at the plate area, flow rates, removal efficiencies, acceptable solids loading etc of the units you are considering.
Regards
Ashtree
"Any water can be made potable if you filter it through enough money"
"You are probably going to need a lot more area or a lower loading rate if most of your droplets are a lot smaller than 60 micron."
I would agree with bimr comment on design and construction of such a unit. Buy one off the shelf if you can. But look at the plate area, flow rates, removal efficiencies, acceptable solids loading etc of the units you are considering.
Regards
Ashtree
"Any water can be made potable if you filter it through enough money"
- Status
Similar threads
- Locked
- Question