Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

coupling 3/8" F.T. to 1/2" F.T.

Status
Not open for further replies.
ryandias

ryandias

Automotive
Joined
Jul 28, 2006
Messages
197
Location
CA
I am trying to find a NON custom option to couple 3/8 inch fine thread to a 1/2 inche fine thread (male to male).

I can't seem to find anything in McMaster or online. Anyone know of an option (not custom machined).
 
Sort by date Sort by votes
on the 3/8" side. Strength is an issue. I am not sure how badly an effect rethreading over already threaded (dissimilar) material will be.

I am not especially fond of this option though.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

jzecha
  • Locked
  • Question Question
Inspect or Gauge for a 38.000"-8 ACME-2G Thread
Replies
4
Views
528
Tmoose
Tmoose
CanosSSCS
  • Locked
  • Question Question
Dual bending for 1/2" OD SS tube
Replies
16
Views
852
EdStainless
EdStainless
Adz123
  • Locked
  • Question Question
Design Ideas for a "Fused" Solution
Replies
10
Views
688
MintJulep
M
just_some_shmuck
  • Locked
  • Question Question
Drawing material callout: "material XYZ or Eq."
2
Replies
20
Views
2K
Christine74
Christine74
DAVIDSTECKER
  • Locked
  • Question Question
Connecting Link; 3/8" Chain
2
Replies
29
Views
1K
DAVIDSTECKER
DAVIDSTECKER

Part and Inventory Search

Sponsor

Back
Top