K
Kardon
Guest
I am new to Solid Works 2008 but vary familiar with Catia V5 R15.
I am attempting to model a rubber hose under forces of gravity and drag. The hose is supported by a hinge restraint and starts out horizontally. Essentially I want to apply various drag forces and study where the hose rests in the air in relation to the horizontal starting point.
Problem 1:
The problem is when running the analysis I get a large displacement error. I also tried activating the large displacement flag and now the analysis fails.
Problem 2:
My study type is set to static and I have attempted to change the study type however, Cosmos will not show any analysis types other than static.
Any help on this issue would be amazing and very much appreciated.
I am attempting to model a rubber hose under forces of gravity and drag. The hose is supported by a hinge restraint and starts out horizontally. Essentially I want to apply various drag forces and study where the hose rests in the air in relation to the horizontal starting point.
Problem 1:
The problem is when running the analysis I get a large displacement error. I also tried activating the large displacement flag and now the analysis fails.
Problem 2:
My study type is set to static and I have attempted to change the study type however, Cosmos will not show any analysis types other than static.
Any help on this issue would be amazing and very much appreciated.
