Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cosmos & structural steels

Status
Not open for further replies.

PLCKing

Mechanical
Joined
Jan 18, 2007
Messages
20
Location
CA
I have a frame made out of 5"X4"X3/16" HSS. I want to run some load analysis and I want to compare the strenght results if the top X beam is HSS or an Angle beam (all other beams will be HSS). For this analysis, you need to use the beam mesh, but how does the beam mesh know if the X beam is HSS or angle? Are the results going to be the same for both cases? Another option is to use a solid mesh, but that not practical because of the high computation time, and I don't think the results will be as accurate. Any suggestions?

PK
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top