Default setting in /tools/document properties/annotations display/ is set to display all types and works fine in part drawings. However it does not display in assembly drawings. We have to insert model items and check the cosmetic thread. Any thoughts on getting ALL drawing to default the same way, cosmetic threads shown?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Cosmetic Thread Display in Assembly Drawings
- Thread starter sdb999
- Start date
You have to use that command to get them to show. There is no hack or settings that will make this automatically show every time you place a file inside a drawing. you will have to set it each time.
Regards,
[COLOR=white blue]Scott Baugh, CSWP[/color]![[borg2]](/data/assets/smilies/borg2.gif "[borg2] [borg2]")
faq731-376
Regards,
[COLOR=white blue]Scott Baugh, CSWP[/color]
faq731-376
- Thread starter
- #3
Not as far as I know... no.
Regards,
[COLOR=white blue]Scott Baugh, CSWP[/color]
faq731-376
Regards,
[COLOR=white blue]Scott Baugh, CSWP[/color]
faq731-376
- Status
Similar threads
- Question
- Locked
- Solved
- Locked
- Question