Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Correct form for a diameter dimension across an non-visible center
- Thread starter TLump
- Start date
MikeHalloran
Mechanical
I have used a double arrowhead to get the point across.
I have no idea if that's standards-compliant.
Mike Halloran
Pembroke Pines, FL, USA
I have no idea if that's standards-compliant.
Mike Halloran
Pembroke Pines, FL, USA
double arrowhead or a jogged arrow are accepted, though as Mint says, better to use an unambiguous detail even if you have to add an extra view just for that one detail.
Jim Sykes, P.Eng, GDTP-S
Profile Services TecEase, Inc.
Jim Sykes, P.Eng, GDTP-S
Profile Services TecEase, Inc.
- Status
Similar threads
- Question
- Question
- Question
- Locked
- Question
