cord rotation

[in2010in]

Hi

For example take a rectangular block having 4 holes or slots on 4 sides like B0, B90, B180, B270...I generated program B0 is main Remaing all "LOCAl" but Special Output I used "USE MAIN MCS" bcoz my work offset(G55) same for all 4 sides.
My program verification shows everything perfect , But when I post the nc output at B180 side "Z" values appering in "Y" , "Y" values appering In "Z" so how to change this.

And also I am not getting "B" value in my out put at B180 side.

Just see pic what I attached.
pls help me how to comeout .
soory for my English yaa

Thnks
UGNX6

 

[EngineerTex]

You would likely be better off posting this on the Machines & Machining Engineering forum.

http://eng-tips.com/threadminder.cfm?pid=281

Engineering is not the science behind building. It is the science behind not building.