I would like to manufacture copper hardware for a three-circuit card assembly stackup. The hardware would include simple stand-offs, basically just thick walled tubing, and some threaded rods and spindles. Currently the hardware is an aluminum alloy. My goal is to take advantage of the thermal conductivity of copper but I'm uncertain of the copper alloy to use for the threaded parts.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Copper Hardware
- Thread starter jot
- Start date
- Status
Similar threads
- Locked
- Helpful tip
- Locked
- Question