Coordinate System not transferred to post-processor

[Settler]

Hello all,

I have an analysis of a model created in a rectangular coordinate system. However, I want to see the radial stresses at some point. This is why I created a datum CSYS.

In the results visualization mode, when I go to Tools -> Coordinate System and Selecting as Data Source the Current ODB I cannot see my datum csys.

Any idea on how to transfer it in results mode?

Thank you very much.

 

[IceBreakerSours]

Result->Options->Transformation->User-specified Transform Type

Are you new to this forum? If so, please read these FAQ:

http://www.eng-tips.com/faqs.cfm?fid=376

http://www.eng-tips.com/faqs.cfm?fid=1083