Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Cooling tower chemical treatment
- Thread starter cme
- Start date
Hi CME,
Conductivity is used primarily to control blowdown (limiting cycles of concentration and preventing precipitation of solids).
pH is used primarily to meter chemical.
The best resource is a REPUTABLE water treatment vendor. Check references first, then consider what he/she says.
The answers will vary based on your fresh water characteristics, where the cooling tower is located, etc...
Good luck with it!
Old Dave
Conductivity is used primarily to control blowdown (limiting cycles of concentration and preventing precipitation of solids).
pH is used primarily to meter chemical.
The best resource is a REPUTABLE water treatment vendor. Check references first, then consider what he/she says.
The answers will vary based on your fresh water characteristics, where the cooling tower is located, etc...
Good luck with it!
Old Dave
Take a look here!
- Status
Similar threads
- Question