Converting simple models from Abaqus to Ansys format

[DrBwts]

Is there a 3rd party (preferably freeware) program that will convert simple models from Abaqus to Ansys format & vice versa?

I dont really want to reinvent the wheel but if I have to then I have to.

I dont have an Ansys license but one the pieces of software I am using will only deal with Ansys models.

Thanks

Nic

 

[bkal]

If you have an ABAQUS licence, it comes with converters usually called aba2ans or similar.

 

[IceBreakerSours]

Nic: I do not know if there is a free utility out there. If the model is simple, then translator utilities that come with solvers should be good enough. I know Abaqus has one such utility, as bkal mentioned above. If you have access to HyperMesh, then it will allow you to perform the translation.

*********************************************************
Are you new to this forum? If so, please read these FAQs:

http://www.eng-tips.com/faqs.cfm?fid=376

http://www.eng-tips.com/faqs.cfm?fid=1083

 

[aerostress82]

This kind of code was actually compiled by some guys in Nastran forum. Here:

http://www.eng-tips.com/viewthread.cfm?qid=401488

Spaceship!!


Aerospace Engineer, M.Sc. / Aircraft Stress Engineer with 7 years of experience
(United States)

 

[DrBwts]

Thanks for the pointers, I have no idea why I didnt try Abaqus's in built translators, too close to the problem I guess.

@aerostress82: I tried their converter & have posted on that thread the results (it didnt work) thanks for the link.

Nic

 

[IceBreakerSours]

You might want to work with flat input decks before you attempt the translation.

*********************************************************
Are you new to this forum? If so, please read these FAQs:

http://www.eng-tips.com/faqs.cfm?fid=376

http://www.eng-tips.com/faqs.cfm?fid=1083

 

[DrBwts]

What do you mean "flat"?

 

[Dave442]

flat input deck = no part or assembly definitions

Before you write your input file in CAE go to Model -> Edit Attributes and check the box that says "Do not use parts/assemblies in input files"