Poorpaulus
Automotive
Can this be done? I have exported a drg out of Solidworks and there are loads of splies. Can these be easily converted into polylines without having to through them one-by-one?
Paul.
Paul.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Convert Splines to Polylines
- Thread starter Poorpaulus
- Start date
- Status
Try dotsoft, they have a routine called spl2pl that converts splines to polylines.
- Thread starter
- #4
- Thread starter
- #5
Poorpaulus
Automotive
Just one more thing, I can't seem to get this to work on 2000LT.
Again, does it work on 2000LT?
Paul.
Again, does it work on 2000LT?
Paul.
This information is very important, isn't it?
1st: Buy the "LT-Extender"!!!-> install the ETV 1-9 or run the lisp... (
2nd: Try to save as R12.dxf...What happened?
Lothar
ADT 2004
ACAD 2002
- Status
Similar threads
- Locked
- Question
