HugoR
Industrial
- Oct 9, 2009
- 10
Hello,
Sorry it is my third thread on the subject but I was unable to find the answer anywhere.
I run my optimization and the log ends on a positive note:
"OPTIMIZATION HAS CONVERGED.
FEASIBLE DESIGN."
Yet, in Hyperview no matter the iteration the density of my elements is never close to 1. On the 80th and last iteration I get about 0.02 density for the first elements to even display. Therefore, if the design has converged and meets the requirements, what density is supposed to give me my solution? Or is something wrong?
Hugo
Sorry it is my third thread on the subject but I was unable to find the answer anywhere.
I run my optimization and the log ends on a positive note:
"OPTIMIZATION HAS CONVERGED.
FEASIBLE DESIGN."
Yet, in Hyperview no matter the iteration the density of my elements is never close to 1. On the 80th and last iteration I get about 0.02 density for the first elements to even display. Therefore, if the design has converged and meets the requirements, what density is supposed to give me my solution? Or is something wrong?
Hugo